? An executive summary of the lab, The executive summaries
with the corresponding names should be included in the single lab report.
? Objective(s): State the goals of the experiment.
? Procedure: State the implementation steps.
? Results: Must include waveform chart plot results of simulation and actual
test runs for the MSD system as well as the parameter values used such as B,
K and conversion factor value for calibration. Include screen capture of
Labview block diagram program.
? Analysis: This section will include all analysis of your results.
Compare the model simulation to the run of the real system. Is the model a
good approximation of the system? Adjust K and B coefficients if necessary
to try to match the simulation as close as possible to the results of the actual
test run. For the waveform decay how can the model formula be modified to
accurately represent the decay? How are the B and K values represented and
affected in the actual MSD system? Why are four different damping
coefficients used?
*Please be aware that any plots and print screens in your report should be
displayed appropriately so that information can easily be conveyed. They should
be large and legible. Poorly presented plots / print screens will not be accepted and
points will be taken off.
